← Info bank · Site home

Cumbria Multi-Day Utility Outage Plan

Immediate contacts

Electricity procedure

1. Establish the scope. Check whether neighbouring properties or streetlights are also off. If only the property is affected, inspect the consumer-unit trip switch if it is safe to do so; Electricity North West identifies this as the safety device that isolates the property’s supply.[10]
2. Report and track it. Check ENWL’s live power-cut information and report the outage online, or call 105. The 105 line is open 24 hours a day, 365 days a year.[11][12]
3. Treat damaged equipment as live. Keep well away from fallen lines, damaged cables and electrical equipment. Report network hazards on 105 or 0800 195 4141; use 999 where there is an immediate danger to life.[2][10]
4. Prevent restart and surge hazards. Turn off heat-producing appliances such as ovens, irons, electric fires and fryers, and unplug sensitive equipment such as TVs and computers. Leave one light switched on as a simple restoration indicator.[13][10]
5. Conserve heat, food and communications. Close curtains and unused rooms, keep fridge and freezer doors closed, use battery-saving mode on phones and get updates from a battery or wind-up radio. ENWL advises that a closed fridge should remain cold for at least four hours and a freezer for about 24–48 hours.[14][10]
6. Protect medically dependent people. Medical equipment should have a tested battery plan agreed with its provider. ENWL asks people lacking backup for essential equipment to contact the medical provider or call 0800 195 4141; its free Extra Care register is open to anyone who may struggle during an outage.[6][14]

Water procedure

1. Check the kitchen cold tap. If cold water is available but hot water is not, the fault is likely within the property’s hot-water or internal plumbing system. Check neighbours and inspect for an internal leak before assuming a network failure.[15]
2. Check the local incident map. Use United Utilities’ Up My Street service for Cumbria supply incidents. If nothing is shown and more than one property is affected, report it online or call 0345 672 3723 rather than emailing.[4][16][15]
3. Follow the exact water-quality instruction. Do not independently assume that disrupted water must be boiled—or that it is safe after boiling. United Utilities will issue a specific “boil before use” or “do not use” notice by SMS, letterbox notice, social media and local press when required.[17]
4. Plan for an extended interruption. United Utilities may establish bottled-water collection points for an extended loss of supply. It may deliver to Priority Services customers unable to collect because of disability, age, mobility, young children or medical need; for registered customers, the company says it will try to provide alternative water if supply is likely to be off for more than 12 hours.[18][17]
5. Keep a household reserve. GOV.UK’s preparedness guidance cites 2.5–3 litres of drinking water per person per day as a survival minimum and about 10 litres per person per day for drinking, basic cooking and hygiene, with extra for medical needs, babies and pets.[19]

Radio and alerts

Write the appropriate BBC Radio Cumbria FM frequency on paper and store it with a battery or wind-up radio, torch and spare batteries. GOV.UK specifically recommends keeping local frequencies in the household emergency plan because internet and television may fail during a power cut.[13][19]

UK Emergency Alerts are broadcast by nearby mobile masts to compatible devices on 4G and 5G; they do not require mobile data, Wi-Fi, an app, registration or location services. A device that is switched off, Wi-Fi-only or connected only to 2G/3G will not receive them, so keep at least one compatible phone charged, updated and with severe/extreme alerts enabled.[20][21]

On receipt, stop and follow the alert’s instructions. The system supplements rather than replaces local radio, television, official social channels and utility updates.[22][20]

Backup-power specification

The original UK Anker SOLIX C1000 has a 1,056Wh battery and 1,800W inverter output. Its 100W USB-C port supports 20V/5A, alongside a separate 30W USB-C port; this matters because Starlink specifies 100W USB Power Delivery at 20V/5A for optimal Mini operation when using its USB-C-to-barrel accessory cable.[23][24][25]

Starlink’s Mini specification sheet lists average consumption of 25–40W, a 12–48V DC, 60W input rating and a 100W, 20V/5A USB-PD requirement with the Starlink USB-C-to-barrel cable. Starlink separately states that USB-PD below 65W will not work and that performance is guaranteed only with the supplied power supply and cable.[24][26][27]

Model check: these figures apply to the original C1000, 1,056Wh (A1761). The newer C1000 Gen 2 is a different 1,024Wh product.[25][28]

Expected runtime

Anker recommends estimating practical AC runtime as battery capacity multiplied by about 0.85, divided by the connected load. That gives approximately 898Wh usable through the AC inverter from a new, fully charged 1,056Wh C1000; Anker notes that temperature, battery condition, standby consumption and changing load alter real results.[29][30]

The following planning figures use Starlink’s 25–40W published range and an explicit allowance of 30Wh per day for phone charging—roughly a planning budget, not a manufacturer specification for any particular phone. They exclude laptops, lighting, heaters, fridges and the station’s idle draw.

For Mini alone, continuous theoretical AC runtime is about 22–36 hours across the 40–25W range. Direct USB-C/DC operation should usually avoid the AC inverter’s larger conversion loss; Anker suggests DC or USB loads can be nearer 90% efficient, which would give about 950Wh usable, or approximately 24–38 hours for Mini alone.[31]

Recommended operating plan

For a genuinely multi-day outage, do not leave Starlink running continuously. Use two or three scheduled online windows totalling 4–8 hours per day, download essential information for offline use, charge phones during those windows, then shut down the dish and all unused C1000 outputs; this turns the original C1000 into a roughly 2.6–6.9-day communications reserve under the assumptions above.

The simplest, manufacturer-supported arrangement is the Mini’s supplied mains power supply connected to the C1000 AC outlet. The more energy-efficient arrangement is the C1000’s 100W USB-C port plus Starlink’s specified USB-C-to-barrel cable; do not use the C1000’s 30W USB-C socket for the Mini, and keep the cable run dry, protected and within Starlink’s requirements.[24][25]

Reserve the 30W USB-C and USB-A outputs for phones. Keep emergency alerts enabled, but recognise that Starlink cannot itself deliver a cell-broadcast Emergency Alert to a phone with no working 4G/5G connection; use Starlink for official web updates and messaging, and retain the FM radio as the independent fallback.[21]

If more than about four hours of connectivity per day is required for several days, add a charging source or more storage. The C1000 accepts solar input up to 600W according to its user guide, while its compatible 1,056Wh BP1000 expansion battery doubles nominal storage; actual solar recovery depends heavily on panel size, siting, season and Cumbria weather.[32][25]

Ready-state checklist

• Store 105, 0345 672 3723, the household BBC Radio Cumbria frequency and key medical contacts on paper.
• Keep the C1000 charged; verify the exact model and periodically test both the Mini’s supplied AC arrangement and any planned USB-C/DC cable.
• Pre-set phone low-power modes, download offline maps and retain at least one separate phone power bank.
• Keep the radio, torch and spare batteries together where they can be found in darkness.[14][13]
• Maintain bottled water, no-cook food, hygiene supplies and essential medicines for several days.[19]
• Register eligible or potentially vulnerable household members with ENWL Extra Care and United Utilities Priority Services before an incident.[7][6]

← Offline hub · Faraday / no-network pack